Inventor Kit For Arduino By Kitronik

Inventor Kit for Arduino by Kitronik

The Kitronik Inventor's Kit for Arduino is a great way to get started in the classroom with programming and hardware interaction with the Arduino. This inventor's kit includes everything you need to perform ten experiments, which include the use of LEDs, motors, light sensors and capacitors.

The Arduino is an open source codable electronic platform for anyone making interactive creations. The Arduino board can handle sensor inputs and control outputs such as LEDs and motors.

The code that is written in the Arduino controls it. This code has been created using the Arduino development environment and the Arduino programming language. When the code is complete, it is easily transferred to the Arduino board via a simple USB cable.

To help you get started, an easy-to-follow training book that guides you through the creation of the ten experiments is provided. You don't need any programming knowledge as the instruction book will guide you through every step of the process. In no time you will be programming and building circuits!

• This kit must be assembled.
• No soldering is required, and you can create your first circuit in minutes!
• The Arduino UNO is not included in this kit.
• This kit is available individually or in sets of 20.
• Carry out the ten experiments described in the step-by-step guide provided.
• To perform the ten experiments, all the necessary components are provided.
• For rapid prototyping, a small prototype breadboard is provided.

Inventor Kit for Arduino: content, requirements and resources

Contents : 

• 1 x Mounting Plate.
• 1 x 7 Segment Display.
• 1 x Servo.
• 1 x Potentiometer - Vertical Type (finger adjust) 100K.
• 1 x Finger Adjust Spindle.
• 4 x Plastic Spacer 10mm.
• 1 x Small Prototype Breadboard.
• 1 x Terminal Connector.
• 4 x Push Switch.
• 1 x Motor.
• 1 x Transistor.
• 2 x Red 5mm LED.
• 2 x Orange 5mm LED.
• 2 x Yellow 5mm LED.
• 2 x Green 5mm LED.
• 1 x RGB 5mm LED.
• 1 x Fan Blade.
• 5 x 2.2KΩ Resistor.
• 5 x 10KΩ Resistor.
• 10 x 220Ω Resistor.
• 20 x Male to Male Jumper Wires.
• 1 x 470uF Electrolytic Capacitor.
• 1 x Piezo Element Buzzer.
• 4 x Pan Head M3 Machine Screw.
• 1 x Phototransistor.

Prerequisites :

• An Arduino board such as The Maker Uno Plus.
• Phillips screwdriver.
• Screwdriver for terminal block.
• Micro-USB cable.

Resources :

• Tech Talks - live stream playback.